Site Overlay


Seeking help to figure out if it it is a RAM issue required: Clarification would be appreciated, Jonathan. Any special cooling requirements? Page 1 of 2 1 2 Last Jump to page: Here’s how my OC’ing of QX turned out: Also, I’m not sure if your memory “likes” CL2.

Uploader: Vulmaran
Date Added: 25 August 2018
File Size: 44.46 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 99026
Price: Free* [*Free Regsitration Required]

i65G R compatible apg list

Any special cooling requirements? I’m moving soon and disp,ay started putting lots of stuff into storage, so consolidation is 775i65g. It doesn’t really make sense for the BIOS to hang on code 20 here. With meter on resistance scale red probe on the orange wire 3. With vga cable on port or off the post code is always the same. This disclaimer is brought to you thanks to the BSA. This site hosts no abandonware.

Hopefully it’s not mislabeled like a lot of other DIMMs on ebay. Does win7’s device manager show any errors for your video card?


PCTreiber Forum

Clarification would be appreciated, Jonathan. If so why the board still can turn on and display bios codes in the debug card stopping on the 13 20, Can some one help me debug this, i whant to understand if the problem is in this component or not.

I’m not sure if these tweaks will cause problems yet, but I’ll definitely try. If BIOS starts running, southbridge is mostly ok.

Any ideas anyone would be verrrrry appreciated! I can’t recommend which video card model might be best. Dear Sirs, I am using a i65G R3. Both of these chips dispaly perfectly, so I know the boards are good.

ASRock > i65G R

Results 1 to 10 of Hi, the bios is AMI, i have try clean 7775i65g the slots and i measure 2. I have reflash bios with williem programmer. I think I had tried to restart with CPU power saving functions off, but I need to try again to really confirm.

Board works fine with Celeron This is my current situation: I tried to install display drivers only but I get the same problem Steps that i have tried: Went to 3,2GHz but not sure if it’s stable.


I was hoping all will work now but I remained with the same problem. I have reset the bios, that was one of the first things i do.

Do you have a PCI graphics card? Are you able to drop the multiplier below 6 on the k? ProfJim asked me for my PC specs, they are as follows: Intel Core 2 Quad Q 2. It can’t go lower.

Find Dixplay Posts by ChaosLegionnaire. You do not have the required permissions to view the files attached to this post. I wasn’t aware of steppings before, and I realized later that the E I have is R0 stepping, not M0 like it says on the supported list.

© 2020 All rights reserved