Site Overlay


Contoso Interface device type: Restarting the computer may resolve the issue. Remove the smart card reader that is causing this error message. This occurs if the resource manager attempts to cancel a command to the smart card reader when the smart card service is shutting down or after a smart card is removed from the smart card reader and the command could not to be canceled. The smart card may be defective. I think drivers for Windows 10 are messy.

Uploader: Faejind
Date Added: 12 September 2013
File Size: 37.86 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 48546
Price: Free* [*Free Regsitration Required]

This prevents the service from managing the smart card reader that was added.

This topic has been locked due to inactivity for a long period of time. For example ‘Contoso Smart Card Reader 0’ is constructed from the following information: This occurs when a smart card reader fails several times to respond properly to the IOCTL, which indicates whether a smart card is present in the reader.

Smart Card Reader Device unit: A number of events can be used to monitor smart card activities on a computer, including installation, use, and errors. Instead, the name is constructed from three device attributes that are queried directly from the smart card reader driver.


What should I do? There is not enough system memory available.

Smart Card Events

You cannot use the smart card reader until the issue is resolved. This can indicate hardware failure, but this error can also occur if a smart card or smart card reader is removed from the system while an operation is in progress.

Message 6 of 6. Smart card Plug and Play events. I have the same question. The smart card may be defective. Choose the type you’d like to provide: Message 5 of 6.

Supported CCID readers/ICCD tokens

Our new feedback system is built on GitHub Issues. Actualy, I did that and it’s still not working.

A smart card reader did not properly respond to a request for information about the device, which is required for constructing the smart card reader name. There are no open issues.

An unknown error occurred while monitoring a smart card reader for smart card insertions and removals. The Smart Card resource manager does not use the device name from Device Manager to describe a smart card readder.


This can leave the smart card reader in an unusable state until it is removed from the computer or the computer is restarted.

Smart card Plug and Play could not obtain the device ID for the smart card. Didn’t find what you were looking for? Message 4 of 6.

After I eject the card and put it back again, the reader is not responding.

Contoso Interface device type: Message 2 of 6. The following three attributes are used to construct the smart card reader name: You may also leave feedback directly on GitHub. Message 1 of 6. By using this site, you accept the Terms of Use and Rules of Participation. Smart card Plug and Play successfully installed a minidriver for fard inserted card.

© 2020 All rights reserved