Site Overlay

DRAFTMASTER SX DRIVER

Turn the plotter off and then on again to clear the display. Javascript is disabled in this browser. Turn the plotter off and then on again before plotting. Then, check the following and start over:. Plotter parts have been changed pinch wheels, for example. Load a sheet of E or D size polyester film in the plotter.

Uploader: Kazranris
Date Added: 7 March 2006
File Size: 13.95 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 19429
Price: Free* [*Free Regsitration Required]

Modify your browser’s settings to allow Javascript to execute. The pen holder will move across the platen.

HP DraftMaster SX, RX, MX, SX Plus, RX Plus, MX Plus plotters – Internal Demo Plots

If it does not have a paper cutter, use a sharp blade or another cutting device. Javascript is disabled in this browser.

Rotate the page 90 degrees clockwise and reload the media draftmastee the plotter. When this process is complete, the plotter will display Cut page, rotate 90 degrees.

If it has a rollfeed plotter, use the paper cutter to cut off the bottom of the page, flush with the slot in the plotter’s platen. The message Calibrating will display. How does HP install software and gather data?

  IA92 MODEM DRIVER

The Virtual Agent is currently unavailable. When reloading polyester film, place the writing surface face up; make sure the left pinch wheel is correctly aligned with the left edge of the plotting media. Load a black drafting pen in stall 8 of the pen carousel.

If the calibration fails, the message Calibration failed will display. The pen holder will move across the media several times, sensing the draftmastter of the square just drawn. Then, check the following and start over:. When the calibration procedure is complete, the message Calibration complete will display. Load a sheet of E or D size polyester film in the plotter.

Raise the paper-loading lever. Europe, Middle East, Africa.

This page requires Javascript. Turn the plotter off and then on again before plotting. See your browser’s documentation for specific instructions. Additionally, verify that the white stripe on the platen is clean. The cut edge of the media should be along the left side of the plotter.

Plotter parts have been changed pinch wheels, for example. When cutting and reloading the media, place the cut edge along the left side of the platen. Calibrating will display on the front panel and the vraftmaster sequence will begin.

  LOGIC CL GD5446 DRIVER

The plotter is calibrated at the factory using E-size AO polyester film and a black drafting pen. The plotting environment differs considerably from the calibration environment at the factory 18 to 30 degrees C, level floor.

HP DraftMaster I, II, SX, RX and MX Plotters – Plotter Calibration | HP® Customer Support

Turn the plotter off and then on again to clear the display. Asia Pacific and Oceania. This includes both the stripe and the white dots on either side.

Handle the film by the edges so as not to get fingerprints on it. Please try again shortly.

7595C Draftmaster SX Pen Plotter

Remove the media from the plotter. Carefully align the line on the left pinchwheel with the left edge of the media. Make sure the pen is operational.

© 2020 All rights reserved