Site Overlay


Aug 04, Use Google Search box in upper right side of this page. Is there any one that has used the programming software successfully. It even gives instructions to use a Y harness and a Rx pack to run the servo if connected to a load, as the USB cannot carry the current. Email to friends Share on Facebook – opens in a new window or tab Share on Twitter – opens in a new window or tab Share on Pinterest – opens in a new window or tab Add to watch list. Well it dose not work and emailed back and have no response from Hyperion.

Uploader: Ganos
Date Added: 20 May 2017
File Size: 22.94 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 59833
Price: Free* [*Free Regsitration Required]

It would be easier if they company had a real customer service department.

I always considered that to be associated with quality products. Last edited by zeroback; Jul 05, at Skip to main content.

Well it dose not work and emailed back and have no response from Hyperion. Delivery time is estimated using our proprietary method which is based on the buyer’s proximity to the item location, the shipping service selected, the seller’s shipping history, and other factors.

I specifically bought into this stuff at the claim it was easy and they could be moved with the software. If I set all the throws equal in low rates, the adjustment is lost on high rates and vice versa??? I have emailed Hyperion and the response was that the servo must be unplugged from the USB device and then plugged back in.


Hyperion RC servo PC interfase

From what I remember of programming the Hyperion servos for my Supra ailerons and flaps 2 years ago the software doesn’t actually move the servo in real time. Same video I found. Start of add to list layer. Hyperion Atlas Servo Programming.

Hyperion Atlas Dig-servo USB Programing Cable Hp-ti-prgusb

I will not respond to Arduino help PM’s from random forum users; if you have such a question, start a new topic thread. I have some of those servos and programming is a big pain.

Dec 08, Hope that helps Skip. I watched a Utoob video before I bought this stuff and it specifically states that the control at the bottom is to move the servo with the ap. When running the program it found my COM1. Jun 24, Actually it is not an expensive interfacehowever if is just as I suspect it to bea normal serie interface where rxd and txd is looped togetherit is easier to make myself.



My experiences tells me that Hyperion are not helpful with schematics. The servos work when connected to a receiver.

Figuring out the centering took a few try’s but once I got the hang of it that adjustment became easier to guesstimate and dial in. Jul 07, I did some more fine tuning this morning and I forgot to mention that while running this software and nothing else my computer has locked up 3 times and absolutely nothing works.


Sign up now ay remove ads between posts. I believe the 5,6volt zener diodeshould be a 3,3volts. Roswell, Georgia, United States. Seller assumes all responsibility for this listing.

Aug 04, Jul 05, Then the slider bar on the PC is supposed to move the servo. Sell one like this. I have everything installed and wired as instructions and I can’t get the PC to move the servo.

© 2020 All rights reserved